Instructions / Assembly

B (4)

ASSEMBLY INSTRUCTIONS

STEP 2: SLIP SLEEVES

Screw each FEET LEVELER (F) into the bottom of

each BOTTOM POLE (B). Turn clockwise to screw

in place.

STEP 1: Mobile Option

Screw each CASTER (E) into the bottom of each

BOTTOM POLE (B). Turn clockwise to screw in

place. Make sure the Locking Casters are on the

same side.

Use the provided caster wrench to tighten

completely. Failure to do as instructed could

result in the caster stem breaking.

For easiest assembly, do not attach the TOP (A) and

BOTTOM (B) POLES until instructed. Once connected,

these will be the posts for the Rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has

raised horizontal lines inside designed to lock them in

place on the POLE (A+B).

On the BOTTOM POLE (B), place 1 pair of SLIP SLEEVES (D)

at the desired level. Please make sure the arrow faces up

and that the word “TOP” is right side up. Do this for each

BOTTOM POLE (B) and make sure that the heights are

identical for BOTTOM POLE (B).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto the BOTTOM POLE (B). DO

NOT place more than one pair on each BOTTOM POLE (B)

at a time.

STEP 1: Stationary Option

B (4) D (8)

E (4) F (4)

* For safety and stability, the lowest SHELF (C) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D)—this is normal.