Instructions / Assembly

ASSEMBLY INSTRUCTIONS

For easiest assembly, do not attach the TOP (A) and

BOTTOM (B) POLES until instructed. Once connected, these

will be the posts for the Rack.

Note that each POLE (A+B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has raised

horizontal lines inside designed to lock them in place on the

POLE (A+B).

On the BOTTOM POLE (B), place 1 pair of SLIP SLEEVES (D) at

the desired level. Please make sure the arrow faces up and

that the word “TOP” is right side up. Do this for each

BOTTOM POLE (B) and make sure that the heights are

identical for BOTTOM POLE (B).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto the BOTTOM POLE (B). DO

NOT place more than one pair on each POLE (B) at a time.

STEP 2: INSTALL SLIP SLEEVES

STEP 1: Stationary Option

STEP 1: Mobile Option

Screw each CASTER (E) into the bottom of each

BOTTOM POLE (B). Use the provided caster wrench to

tighten completely. Make sure the Locking Casters

are on the same side.

* For safety and stability, the lowest SHELF (C) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D) —this is normal.

Screw each FEET LEVELER (F) into the bottom of each

BOTTOM POLE (B).

* For safety, at least half of the FEET LEVELER (F) stem

must be inside the BOTTOM POLE (B).

* Note: The CASTERS (E) must be tightened completely

against the BOTTOM POLE (B) or caster stem may break

and tipping of rack may occur.

B (4) E (4) F (4)

B (4) D (8)