Instructions / Assembly

ASSEMBLY INSTRUCTIONS

STEP 1: SLIP SLEEVES

* For safety and stability, the lowest shelf should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES—this is normal.

For easiest assembly, do not connect the TOP POLES (C),

MIDDLE POLES (B), and BOTTOM POLES (A) until

instructed. Once connected, these will be the posts for

the rack.

Each POLE (A+B+C) has slight horizontal line indentations

at 1” intervals. Each SLIP SLEEVE (E) has raised

horizontal lines inside designed to lock them in place on

the POLE (A+B+C). On POLE (A), place 1 pair of SLIP

SLEEVES (E) at the desired level. Please make sure the

arrow faces up and that the word “TOP” is right side up.

Do this for each POLE (A), and make sure that the heights

are identical for each POLE (A).

Slide the pair of SLIP SLEEVES (E) until you hear a click to

confirm the pair is locked onto the POLE (A). DO NOT

place more than one pair on each POLE (A) at a time.

Place SHELF (D) on its side and slide the (4)

BOTTOM POLES (A) through the holes in the

SHELF (D). Make sure that the SHELF (D)

corner cylinders are positioned over the SLIP

SLEEVES (C).

Stand the unit upright.

*Note: The level side of the SHELF (A) is the

TOP side (the TRINITY logo on the corner

cylinders should be right-side up.)

**Use a rubber mallet, if needed, to secure

the shelves.

STEP 2: INSTALLING SHELVES

A (4) E (8)

D (1)