Instructions / Assembly

STEP 2

B (4)

N (8)

ASSEMBLY INSTRUCTIONS

STEP 1

L (2)

M (1)

K (2)

B (4)

Screw each CASTER (K & L) into threaded insert of each

BOTTOM POLE (B). Turn clockwise to screw in place.

Make sure LOCKING CASTERS (L) are on same side of

Kitchen Cart.

Use provided caster WRENCH (M) to tighten

completely. Failure to do as instructed could result in

caster stem breaking.

On BOTTOM POLE (B), place one pair of SLIP SLEEVES (N) at

desired height no higher than 3

indentation from bottom.

Make sure arrow faces up and word “TOP” is right-side up. Do

this for each BOTTOM POLE (B). Make sure SLIP SLEEVES (N)

height is identical for each BOTTOM POLE (B).

Note that each POLE (A & B) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (N) has raised

horizontal lines inside designed to lock in place on POLE (A & B).

Slide pair of SLIP SLEEVES (N) until you hear a click to confirm

they are locked onto BOTTOM POLE (B). Do NOT place more

than one pair on each POLE (A & B) at a time.

Note:

There will be a very small gap in-between two locked SLIP

SLEEVES (N)—this is normal.