Instructions / Assembly

Facing side of Kitchen Cart with SIDEBAR (H) attached, slide LEFT ARM (I) unto pole on left side and

RIGHT ARM (J) unto pole on right side. Properly positioned, support wires should be on INSIDE of

poles facing each other. Make sure each collar cylinder is positioned over SLIP SLEEVES (N).

Move to other side of Kitchen Cart and repeat step to install other pair of LEFT ARM (I) and RIGHT

ARM (J).

Note:

• LEFT ARM (I) has an "L" sticker on it and RIGHT ARM (J) has an "R" sticker on it.

• Make sure tops of each pair of support arms are level so BAMBOO SIDE BOARD (D) will lay flat

when installed. Use a rubber mallet, if needed, to secure LEFT ARM (I) and RIGHT ARM (J) and

make them level.

ASSEMBLY INSTRUCTIONS

STEP 7

Attach one pair of SLIP SLEEVES (N) to each pole at 2

indentation

below double line. Slide pair of SLIP SLEEVES (N) until you hear a

click to confirm they are locked onto TOP POLE (A).

N (8)

J (2)

I (2)

indentation

below double line

Double line

indentation