Instructions / Assembly

ASSEMBLY INSTRUCTIONS

STEP 1: CASTERS

STEP 2: SLIP SLEEVES

A (4) E (4)

Note that each POLE (A) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (D) has

raised horizontal lines inside designed to lock them in

place on the POLE (A).

On POLE (A), place 1 pair of SLIP SLEEVES (D) at the

desired level. Please make sure the arrow faces up and

that the word “TOP” is right side up. Do this for each

POLE (A) and make sure that the heights are identical for

POLE (A).

Slide the pair of SLIP SLEEVES (D) until you hear a click to

confirm the pair is locked onto the POLE (A). DO NOT

place more than one pair on each POLE (A) at a time.

A (4) D (8)

Screw each CASTER (E) into the bottom of each

POLE (A). Turn clockwise to screw in place.

Use the provided caster wrench to tighten

completely. Failure to do as instructed could

result in the caster stem breaking.

* For safety and stability, the lowest SHELF (B) should be lower than the 3

notch from the bottom.

** Note: There will be a very small gap in-between the SLIP SLEEVES (D)—this is normal.