Use and Care Manual

STEP 2

Screw each CASTER (I & J) into the bottom of

each BOTTOM POLE (C). Turn clockwise to

screw in place. Use the wrench to tighten

each CASTER (I & J) . Make sure LOCKING

CASTERS (I) are on the same side.

Use the provided caster wrench to tighten

completely. Failure to do as instructed

could result in the caster stem breaking.

C (4) J (2) K (1)I (2)

C (4)

G (8)

On BOTTOM POLE (C), place 1 pair of SLIP SLEEVES (G) at

the desired level no higher than the 3

indentation from

the bottom. Please make sure the arrow on SLIP SLEEVES

(G) faces up and that the word “TOP” is right side up. Do

this for each BOTTOM POLE (C) and make sure slip sleeve

heights are identical for all (4) BOTTOM POLE (C).

Note that each POLE (B & C) has slight horizontal line

indentations at 1” intervals. Each SLIP SLEEVE (G) has raised

horizontal lines inside designed to lock in place on POLE (B

& C).

Slide the pair of SLIP SLEEVES (G) until you hear a click to

confirm the pair is locked onto BOTTOM POLE (C). DO NOT

place more than one pair on each POLE (B & C) at one time.

Note: There will be a very small gap in-between two locked SLIP SLEEVES (G)—this is normal.

ASSEMBLY INSTRUCTIONS

STEP 1