Use and Care Manual

ASSEMBLY INSTRUCTIONS
Carefully move sink against wall at your
desired location. If needed, use a pencil to
mark off mounting height of BRACKET (L).
Position BRACKET (L) on wall, marking off
fastening location on wall through holes on
BRACKET (L). Drill holes in marked locations.
Insert ANCHOR (N) completely into each
drilled hole. Fasten MOUNTING SCREWS (M),
through holes on BRACKET (L), into anchors
tightly with
a screwdriver.
Slightly lift sink and hook flange of sink over
BRACKET (L). Adjust Feet Levelers to ensure
sink is stable and level. Connect Hoses and
Drain to plumbing system.
Note: Bracket is to prevent sink tipping,
NOT for mounting sink to a wall. Do NOT
mount sink to a wall without legs.
STEP 6
L (1) M (2) N (2)
L
M
N
flange
L
© 2019 TRINITY - 800.985.5506
5