Use and Care Manual

ASSEMBLY INSTRUCTIONS
STEP 3
If ANCHORS (H) are required, insert
ANCHORS (H) completely into each
drilled hole. Place partially assembled
unit from step 1 to wall as shown.
Align screw holes on CROSS BEAM (D)
and on LEFT & RIGHT BRACKETS (B &
C) to marked locations. Fasten
SCREWS (G) through these holes into
wall tightly with a Philips screwdriver.
G
H
STEP 4
Attach SHELF (A) to mounted
assembly as shown, making sure
threaded studs on two inner sides
of SHELF (A) fit into notches on
LEFT & RIGHT BRACKETS (B & C).
Fasten NUT (E) onto each threaded
stud with provided WRENCH (F).
© 2023 TRINITY - 800.985.5506
3
G (7) H (7)
E (4)A (1)
A
E