User's Manual

5 6
DESCRIPTION –Transmitter (TX) LED’s
Notes:
1) After synchronization, the mode goes back to its previous selected mode.
2) When TX is OFF and inserted into RX, there will be no synchronization.
3) If the TX goes out of normal range, it will resume its previous status when
it comes back into range.
Mode
SYNC REC
Battery
Status
Out of
Range Mute
TALK O
N
REC
Off:
GREEN
On
REC:
ORANGE
Blink
LED Off
LED +
Vibration
GREEN
On
GREEN
Blink
RED
Blink
RED
On
Vibration
(1 time
only)
Vibration
(3 time
per second)
Vibration
(2 times
per 3
seconds
Vibration
(1 time
per 3
seconds)
LED Off
Vibration
LED
Off
LED Off
LED Off
No
Vibration
No
LED
No Vibration
LED OFF (GREEN OFF , ORANGE OFF, RED OFF)
Vibration
(1 time
only)
Vibration
(3 time
per
second)
Vibration
(2 times
per 3
seconds)
Vibration
(1 time
per 3
seconds)
Quick Set up and Operation
Synchronization of Transmitter and Receiver
The synchronization only needs to be performed the first time a system is
used, or another transmitter is used with a receiver previously synced.
Do not perform the sync operation multiple times; it only needs to be done once
successfully.
1) Turn the transmitter power switch to ON and select the operation mode with
MODE switch and place the transmitter into the receiver.
2) When synchronization is completed, then STATUS LED will stop flashing. If
vibration mode is enabled, then it will vibrate once.
Normal Operation
1) With the transmitter synced, remove it from the receiver, plug in the lapel
microphone (if used) and place the transmitter into the leather pouch on user’s
belt.
2) When user removes transmitter from the receiver, STATUS LED for each
transmitter and receiver will light constant green. To start recording, press the
REC button and the LED beneath REC button will blink red.
3) If the recording command from VPU is received, recording will start and the LED
beneath REC button will flash red. If the record command was not received and
a recording was NOT STARTED, the REC button will NOT flash red.
4) If the stop command from VPU is received, recording will end and the LED
beneath REC button will be off.
Out of Range
1) The transmitter will alert user by flashing the RED LED of STATUS.
2) The transmitter needs to move closer to the receiver and the link will be re-
established without physically “re-syncing” the TX with RX when user returns to
normal range. STATUS LED will light constant green when link is back to
normal range.
Mute Button
1) Mute button can be used to mute the user’s audio stream when needed.
2) In recording mode; press mute button on the transmitter, then ORANGE LED of
STATUS will flash.
Low Battery Warning
1) If low battery indicator (RED) starts flashing, return the transmitter to the
receiver to be fully charged.
2) The charge LED indicator will light constant green when the unit is fully
charged.