User's Manual

ManualsBrandsTrinus Systems ManualsCamera & PhotoBody Worn Camera System

---------------------------------------------------------------------------------------

Read this user guide carefully for safe operation and proper

use of the product.

Features and specifications are subject to change without

notification.

Arbitrator Body Worn Camera System

ARB-SA366

User Guide

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and

operated with a minimum distance of 5 millimeters between the radiator and

your body. This transmitter must not be co-located or operated in

conjunction with any other antenna or transmitter.

Version 1.00

FCC ID : ROYSA366PBWC

This device complies with part 15 of the FCC Rules. Operation is subject to

The following two conditions : (1) This device may not cause harmful interference,

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

Caution: Any changes or modifications in construction of this device which

are not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits

for a class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in

a residential installation this equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications, However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures :

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

-Consult the dealer or an experienced radio / TV technician for help.

Summary of content (10 pages)

PAGE 1
FCC RF Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 5 millimeters between the radiator and your body. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Arbitrator Body Worn Camera System FCC ID : ROYSA366PBWC This device complies with part 15 of the FCC Rules.
PAGE 2
AUDIT LOG INFORMATION-2 CAUTION 1. When Using the Battery Danger (1) Misusing the battery may cause the battery to get hot, explode, or ignite and cause serious injury. Be sure to follow the safety rules listed below: - Do not place the battery in fire or heat the battery. - Do not install the battery backwards so that the polarity is reversed. - Do not connect the positive terminal and the negative terminal of the battery to each other with any metal object (such as a wire).
PAGE 3
CAUTION AUDIT LOG INFORMATION-1 Category Event Log Item Parameter Recording Start [factor] [mode] [factor] = Start Event Name [mode] = Event / Cont Stop Recording Stop [factor] [Event Name] [factor] = Event name (when recording stopped) I/O status change event 2'nd camera attached/detached USB attached/detached Power supplied/removed Wi-Fi disconnected with [mode] [Electric field strength] [mode] = ST1/ST2/AP [MAC] = Mac address of AP [FREQ] = Channel [SSID] = SSID of AP [Electric fiel
PAGE 4
SPECIFICATIONS-2 CAUTION Warning Do not continue charging the battery if it does not charge within the specified charging time. Doing so may cause the battery to become hot, explode, or ignite. There is a risk of explosion if the battery is replaced by an incorrect type. 2. While Charging Caution The temperature range over which the battery can be charged is 0°C to 45°C. Charging the battery at temperatures outside of this range may cause the battery to become hot or to break.
PAGE 5
SPECIFICATION-1 Category Camera General PACKAGE CONTENTS FOR SA366 (Main) Item Specification Video Resolution 720p / 360p View Angle H :130° / V : 67° Frame Rate (FPS) 30fps Still Photo Resolution 1280 x 720 / 640 x 360 (pixel) Minimum Illuminance Color : 1.2lx, BW : 0.
PAGE 6
DESCRIPTION – MAIN CONTROLLER#1 The SA366 is mainly worn by police officers in order to record the video and audio during the incidents or on patrol. The recorded video and audio data is highly compatible to Arbitrator360° HD in-car digital video recording system, and can offer seamless operation with it and SA366 data to the customers . Port for 2nd Camera Mute BASIC OPERATION-6 5) Recording The following are descriptions of how to record and play images with the camera.
PAGE 7
DESCRIPTION – MAIN CONTROLLER#2 BASIC OPERATION-5 4) LED Indication-3 LED Name ST1 ( ST2 ( AP ( ) ) ) Wireless LAN Link ( ) Operation LED Operation Connected with VPU ● : Lit Transfer Data ☀ : Blinking Connected with BES ● : Lit Finished Uploading ● : Lit Under Uploading ☀ : Blinking Transfer Data ☀ : Blinking Connected with Smartphone ● : Lit Streaming Video ☀ : Blinking Transfer Data ☀ : Blinking Wireless LAN Linked ● : Lit Searching Wireless LAN ☀ : Blinking Malfunction at
PAGE 8
DESCRIPTION – 2nd CAMERA BASIC OPERATION-4 4) LED Indication-2 LED Name REC ( ) ● : Lit Snapshot is recorded ☀ : Flash Once Classify is recorded ☀ : Flash Once Fail to Start Recording ☀ : Blinking 3 times Receive Command of PC ☀ : Blinking Audio Mute ON ● : Lit Under connected with PC ☀ : Blinking Time > 3 Hours ● : Lit 1 < Time < 3 Hours ● : Lit Time < 1 Hours ☀ : Blinking Card Full, Card Error ● : Lit Full Charged ● : Lit > 50% ☀ : Blinking 15% ~ 49% ☀ : Blinking < 15% ☀ : B
PAGE 9
BASIC OPERATION-3 FEATURES 4) LED Indication-1 The SA366 is real time surveillance camera, with compressed by H.264 and MJPEG from HD image. It includes HD video and audio which will be encrypted and saved at standard SD card. Also it can be live-viewed and played back at smartphone application through Wireless LAN. Its firmware and configuration can be updated via Wireless LAN or USB from server and Wireless LAN has 4 different modes as ST1 / ST2 / AP / OFF.
PAGE 10
BASIC OPERATION-1 BASIC OPERATION-2 1) Buttons Wireless LAN Mode Switch : Recording Button: ST1( ): Station mode for connection with the VPU To start the recording, press the recording button shortly. ST2 ( ) : Station mode for connection with the back End Server (BES) To stop the recording, press and hold the recording button for more than two seconds.