User's Manual

Page 55

E Series Data Radio – User Manual

9. The logging window will display the progress of each

ﬁrmware block transferred and when complete a success

dialogue box appears. Click OK to close this dialogue box

and click “Exit” in the main window to exit the ﬁrmware

update utility.

Note: If a mismatch occurs between selected ﬁle and device

type, an error message will appear.

Hot Standby Controller Firmware

Update

Installation Instructions:

1. Update of the hot standby ﬁrmware uses the ﬁrmware

update utility supplied with the TVIEW+ Management Suite.

2. Start the ﬁrmware update utility from the TVIEW+ front

panel.

3. In the ﬁrmware update utility select device type as “Hot

Standby Controller”.

4. Select the ﬁle containing the ﬁrmware update package

using the “select” button at the bottom of the main window.

After opening the ﬁle the browse window will close and a

5. Ensure that the hot standby controller is powered.

6. Connect the “TVIEW+ cable” to the front or rear system port

of the hot standby controller.

7. On the hot standby controller front panel depress and

hold the “Reset Alarms” button, then momentarily depress

the ﬁrmware update switch using a suitable probe before

releasing the “Display On/Off” button. The ﬁrmware update

switch is located behind the small hole (not labelled) in the

front panel to left of “Reset Alarm” button.

Note: The two LEDs either side of the “Select” switch will be

lit green in this mode.

8. Initiate the ﬁrmware update process using the “Write” button

at the bottom of the main window. Another logging window

will appear.