User's Manual

Page 17
E Series Ethernet Radio – User Manual
Version 08-10
SNMP
The E-Series Ethernet Radios Support SNMP V1 and V2 with all parameters from RFC-1213 [2].
Community Strings
E-Series Ethernet Radio support 2 types of community strings, Read-only and Read-Write.
The read-only community string is used to access any of the read-only objects supported in the ER45e. This string can be up to 32 characters long. The
characters must be alpha numeric.
The read-write community string is used to write to any of the read-write objects supported in the ER45e. This string can also be used to read from any
of the read-only or read-write objects supported in the ER45e. This string can be up to 32 characters long. This string can be up to 32 characters long
and must be textual.
All community strings are cleared after a Factory Default.
Programmer & Diagnostics
Programmer
The programmer is used to set conguration parameters within the ER45e Ethernet radio modem and EB45e Ethernet base station. The utility permits
conguration of modems connected directly to the PC as well as over the air to a remote unit. Conguration parameters can be saved to a disk le for
later retrieval, or used for clone programming of other modems.
The conguration wizard can be used to provide Quick start generic templates.
Diagnostics
TView+ Diagnostics is used to gather diagnostic information about your Trio radios. This diagnostic information is useful in the process of installation,
maintenance and fault nding.
The TView+ Diagnostics software can be installed as part of the TView+ software suite (which includes the E45e, E450, M&K series programmers) or
from the stand alone package (zip le) which can be downloaded from the support section of the Trio Datacom website.
Firmware Updating
Firmware updates are eld programmable. New Firmware packs, containing new features and improvements are available from Trio Datacom’s Web
site (www.triodatacom.com).
Part D – Features