User's Manual

Page 48
M Series Data Radio – User Manual
© Copyright 2004 Trio DataCom Pty. Ltd.
Part H – TVIEW+ Management Suite - Programmer
More detailed information is also available to assist in identifying
components installed in the unit (remote, base station or hot standby).
The additional information provided is:
• Controller Rev refers to the microcontroller firmware component
version for the radio.
• DSP Code Rev refers to the DSP firmware component
version for the radio.
• Processor Board ID refers to the processor board identification
number and hardware revision information for the radio.
• RF Deck ID refers to the RF deck board identification number
and hardware revision information inside the radio.
• Production Build Code refers to the automated production test
and calibration sequence used during manufacture of the radio.
• Hardware indicates whether the radio is half or full duplex.
• Unit Type indicates whether the unit is recognised as a remote
or base station.
• Tx and RX Frequency Range indicates the frequency range
for which the radio is capable of being operated in.
In the case of a base station unit the following additional information is
provided:
• Base Firmware Pack refers to the firmware package version
installed in the base station (front panel) controller which is
separate to the radio installed. There are several components
associated with this firmware package and a single version
number is used to identify them.
• Base Controller Rev refers to the microcontroller firmware
component version for the base station.
Unit Information - Details
Messages
The message window provides a log of error messages occurring
during use of the programmer utility. Several error messages may
occur as a result of a selection.
Status Bar
The status bar is located at the bottom of the main window and
provides information regarding communication actions occurring with
the radio data modem.
Additional fields located on the status bar include:
•
Unit ID refers to the identification label used by the diagnostics
utility. This is currently the same as the unit’s serial number.
•
Mode refers to the type of session established. It can be a File,
Local indicating a local port connection to the unit or Remote
indicating communications is via a radio channel.
•
Rotating bar progress indicator showing data is being
transferred to or received from a unit.