User's Manual

110 Document Number: 0100SM1401 Issue: 12-16
NAT - Point to Multipoint via multiple Repeaters
Host Application
IP: 192.168.0.2/24
Gateway: 192.168.0.1
Entry Point
Network Settings:
IP: 192.168.0.1/24
Router Settings:
WAN IP: 10.10.10.1/24
Route Table Entries:
10.10.10.3 10.10.10.2
10.10.10.4 10.10.10.2
10.10.10.5 10.10.10.2
NAT:
Disabled
Full Duplex Repeater
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.2/24
Route Table Entries:
10.10.10.5 10.10.10.4
192.168.0.0/24 10.10.10.1
NAT:
Enabled
Remote A
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.3/24
Route Table Entries:
192.168.0.0/24 10.10.10.2
Port Forwarding Rules
Enabled All 2300 192.168.1.2 23
Ethernet Device
IP: 192.168.1.2/24
Gateway: 192.168.1.1
Ethernet Device
IP: 192.168.1.2/24
Gateway: 192.168.1.1
Ethernet Device
IP: 192.168.1.2/24
Gateway: 192.168.1.1
Half Duplex Repeater
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.4/24
Route Table Entries:
192.168.0.0/24 10.10.10.2
Port Forwarding Rules
Enabled All 2300 192.168.1.2 23
Remote B
Network Settings:
IP: 192.168.1.1/24
Router Settings:
WAN IP: 10.10.10.5/24
Route Table Entries:
192.168.0.0/24 10.10.10.4
Port Forwarding Rules
Enabled All 2300 192.168.1.2 23
The diagram above provides an example of how to port-forward a Telnet session from the Host application, to an Ethernet
device shown. In order to establish a Telnet session from the host application to the Ethernet device connected to Remote A,
the host application requires the following addressing: [Telnet 10.10.10.3 2300]. This address references Remote A’s WAN
IP and the unique port number allocated to the Ethernet device specified within the port forwarding rule.
Part G – Quick Start Guide
This topology should use Carrier detect collision avoidance.