User's Manual

7
Document Number: 0100SM1401 Issue: 12-16
Part A - Preface
Site Grounding
Ensure that the chassis mounting plate, power supply
(-) Ground, RTU terminal device, and lightning arrester,
are all securely connected to the ground in the building
installation or a common ground point to which an earth/
ground stake is attached.
R&TTE Directive (Europe)
Applies to models TBURQx4xx-Exxxxxxx
In order to comply with the R&TTE (Radio &
Telecommunications Terminal Equipment) directive
1999/5/EC, all radio modem installations must include
an external in-line lightning arrestor or equivalent device
that complies with the following specifications:
• DC Blocking Capability - 1.5kV impulse (Rise Time
10mS, Fall Time 700mS) (Repetition 10 Times)
or 1.0kV rms 50Hz sine wave for 1 minute.
Trio Datacom declares that the Q data radio range
is in compliance with the essential requirements and
other relevant provisions of the Directive 1999/5/
EC. Therefore the Trio Datacom Q data radio range is
labelled with the following CE-marking.
FCC Compliance (Hot Standby Controller Only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction, equipment may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
• Re-orient to relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different to that which the receiver is connected.
• Consult the dealer or an experienced radio/
television technician for assistance.
0891
Industry Canada
This device complies with Industry Canada’s license-
exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.