User's Manual

70 Document Number: 0100SM1401 Issue: 12-16
Mounting Guidelines
The QP hot standby half duplex radio is housed as a 1RU 19” rack mounted unit. There are mounting brackets included for
the front panel, which can be used to secure the unit to the rack. The mounting brackets can be fitted to the side of each
unit in 3 different locations to provide different mounting capabilities: Front Mount, Proud Mount or Center Mount. Refer to
the QB Mounting guide for a graphical representation of the different mounting positions.
The unit should be mounted in a clean and dry location, protected from water, excessive dust, corrosive fumes, extremes of
temperature and direct sunlight. Allow sufficient passive or active ventilation to allow the radio fans to pass air through the
internal heat sink efficiently.
All RF, power and digital I/O connections are made at the rear of the unit. All User interfaces are located at the front of the
unit, this includes: Ethernet interface, Serial COM port interfaces and Auxiliary interface.
Physical Dimensions
19” (483mm) 1 RU rack mount.
Without mounting brackets, D:424 x H:44.45 x W:436.5mm (D:16.7” x H:1.75” x W:17.18”)
Part F – Quick Reference Guide