Instructions / Assembly

ManualsBrandsTriple Clear ManualsKitchenUnder the Sink Point of Use Force Field Water Filtration Kit with a 10 in. Filter

(1) Triple Clear Force Field Filter (A)

(1) Bracket Installation Kit (B) includes:

(1) Mounting Bracket

(4) Mounting Screws

(4) Mounting Anchors

(1) Inlet Component Kit (C)

(1) Outlet Component Kit (D)

PARTS & MATERIALS: (included)

• #2 Phillips Head Screwdriver

• Drill and 1/8 inch Drill Bit

• Stud Finder

• Pencil

• Level

• (2) Adjustable Crescent Wrenches

TOOLS REQUIRED: (not included)

Congratulations! With Triple Clear’s Force Field Filter system, you’re just a

few steps away from triple-filtered water that’s safe, clean and delicious.

INTRODUCTION

This kit includes all the hardware you need to easily install the filter with the

help of some common household tools.

Force Field Filter technology removes 99.9999% of harmful contaminants

through more than 400 layers of filtration with three levels of filtering: 1) a 1um

mechanical filter removes large particles; 2) a carbon filter removes metals, bad

tastes and odors; 3) an electroadsorbtion layer acts like a magnet to remove

negatively charged particles like viruses, bacteria and parasites.

We’re excited to bring our commercial-grade water filtration technology, used

by hotels, hospitals and restaurants, into your home.

5. Place the Triple Clear Force Field Filter into the

bracket and secure tightly by closing the bracket

and turning the wing nut to the right to tighten.

Note: Ensure inlet and outlet are appropriately

located at the top of the filter and oriented so

all lines reach correctly.

6. Insert the line that is connected to the water isolation valve into the inlet of

the filter by pressing it firmly into place until an audible click is heard.

Pull gently to confirm fitting is locked.

7. Insert the line connected to the water faucet into

the outlet of the filter by pressing it firmly into

place until an audible click is heard.

Pull gently to confirm fitting is locked.

6&7

8. Turn on the water supply slowly, inspecting tubing and connections for

any leaks.

Note: In the event of leakage, turn off water supply and take appropriate

action to rectify.

9. Open faucet slowly to “on” position to purge any trapped air from the system

and confirm proper operation. Allow the water to run for 60-90 seconds to

adequately flush the system prior to use.

Note: Water may appear cloudy, which is normal when filter is new.