Manualshelf

Installation Manual

ManualsBrandsTriple Plus ManualsElectronicsLoRa based Ball valve Actuator security system
12345678910
Inserting The Batteries
Loosen the screw on the bottom of the battery compartment to remove the cap using a Phillips-head #1
screwdriver. Place all 4 x CR123 batteries into the compartment with ‘
-
’ end facing out. Place the cap back onto
the compartment. Align the edges of the cap and compartment before tightening the screw to make sure it closes
properly. Press the orange button briey to check the Shuttie LED status color. It should blink green.
1
RED - Error
BLUE - Communication fault
GREEN - Operating
OFF - No power