User Manual
Table Of Contents
- Model 310-Tel T4_ 1
- Model 310-Tel T4_ 2
- Model 310-Tel T4_ 3
- Model 310-Tel T4_ 4
- Model 310-Tel T4_ 5
- Model 310-Tel T4_ 6
- Model 310-Tel T4_ 7
- Model 310-Tel T4_ 8
- Model 310-Tel T4_ 9
- Model 310-Tel T4_10
- Model 310-Tel T4_11
- Model 310-Tel T4_12
- Model 310-Tel T4_13
- Model 310-Tel T4_14
- Model 310-Tel T4_15
- Model 310-Tel T4_16
- Model 310-Tel T4_17
- Model 310-Tel T4_18
- Model 310-Tel T4_19
- Model 310-Tel T4_20
- Model 310-Tel T4_21
- Model 310-Tel T4_22
- Model 310-Tel T4_23
- Model 310-Tel T4_24
- Model 310-Tel T4_25
- Model 310-Tel T4_26
- Model 310-Tel T4_27
- Model 310-Tel T4_28
- Model 310-Tel T4_29
- Model 310-Tel T4_30
- Model 310-Tel T4_31
- Model 310-Tel T4_32
- Model 310-Tel T4_33
- Model 310-Tel T4_34
6
s Do not mistake a downscale reading as an indication that no
potential is present. Dangerous potentials may be present
that may result in user injury.
sWhen replacing the battery, dispose of the depleted battery
in accordance with any prevailing safety or environmental
regulations.
s!Static charge on the face of the meter may cause the
meter to produce inaccurate readings, which could lead to
user injury. This condition is usually observed in dry
climates, when the face of the meter is rubbed with a cloth.
!pply !NTISTAT solution, or mild detergent, to the face of the
meter to dissipate the static charge.
READ THE MANUAL
Read this Instruction Manual carefully and completely.
Voltages and currents within the capability of this test
equipment can be hazardous. Follow the instructions
in this manual for every measurement. Read and un-
derstand the general instructions before attempting
to use this tester. Do not exceed the limits of the tester.
SAFETY CHECK
Double check the switch setting and lead connections
before making measurements. !RE you following all
of the instructions?
Disconnect the tester or turn off the power before
changing switch positions. Do not connect to circuits
with voltage present when switch is in any ohms or
current position.
When replacing fuses, use only specified type fuses
and insert in correct fuse holder.