User Manual

ManualsBrandsTriplett ManualsAccessoriesNon-Contact Forehead IR Thermometer

User Manual

FT2020

Non-Contact IR Forehead Thermometer

Introduction

Congratulations on your purchase of the Triplett FT2020 Non-Contact IR

Forehead Thermometer. Forehead Infrared Thermometers are for non-contact

human temperature measurement. NOTE: These thermometers intended for

general purpose scanning measurements and monitoring of human body

temperature only by slowly moving the sensor across the forehead.

These thermometers are not a substitute for a clinical thermometer. Always use

a clinical thermometer when high accuracy body temperature measurements are

required.

Summary of content (6 pages)

PAGE 1
User Manual FT2020 Non-Contact IR Forehead Thermometer Introduction Congratulations on your purchase of the Triplett FT2020 Non-Contact IR Forehead Thermometer. Forehead Infrared Thermometers are for non-contact human temperature measurement. NOTE: These thermometers intended for general purpose scanning measurements and monitoring of human body temperature only by slowly moving the sensor across the forehead. These thermometers are not a substitute for a clinical thermometer.
PAGE 2
Safety  For cleaning the instrument use a soft dry cloth. Never use a wet cloth, solvents or water. Warning Please read these instructions carefully before using this instrument and keep the instructions and the thermometer in a safe place. • Keep out of reach of children; • Never use the thermometer for purposes other than those it has been intended for. • Follow the general safety precautions when using on children.
PAGE 3
Description 1. IR Sensor 2. Trigger 3. Battery Door 4. LCD 5. Push Buttons Operation A. Body Temperature Measurement Set the Thermometer at body temperature measuring mode by press . Hold the Thermometer by its handle and point it toward the forehead to be measured. Measuring distance should be 2 to 6” (5 to 15cm) Press the trigger to turn the meter on and take a temperature reading. The temperature reading appears in the large display.
PAGE 4
B. Surface Temperature Measurement 1) Set the Thermometer at surface temperature measuring mode by press . 2) Hold the meter by its handle and point it toward the surface to be measured. 3) Press the trigger to turn the meter on and take a temperature reading. "OUT" will be displayed at the left bottom and the adjusted value is displayed at the bottom right. 4) Release the Trigger and the reading will hold for approximately 7 seconds after which the meter will automatically shut off.
PAGE 5
Specifications FT2020 32°C to 42.5°C 89.6°F to 108.5°F 0°C to 60°C 32°F to 140°F ±0.2°C or ±0.4°F 0.1 2 to 6 “(5 to 15cm) 500ms 7 seconds   Model Body Temperature Range Surface Temperature Range Best Accuracy Display Resolution Distance Response Time Display Hold °C / °F Selection Temperature Data Hold Display Backlight Sleep Mode Power By Dimensions 6.   9V (6F22) x 1 6.7”x4.0” x 1.7” (170 x 103 x 42.5mm) Weight 7. 7 oz.
PAGE 6
Caution To avoid damaging the thermometer do NOT submerge it in water. Do not use abrasive cleaners, they will damage the case. The Lens Blow off loose particles using clean compressed air. Carefully wipe the surface with a water-moistened cotton swab. The Housing Use soap and water on a damp sponge or soft cloth. Warranty Information Triplett / Jewell Instruments extends the following warranty to the original purchaser of these goods for use.