User Manual

CAT 5/6 UTP Cable Testing Main Menu
RW CERTIFY ("RWC") UTP: Move the cursor to RW CERTIFY UTP
and press SELECT to start RWC Level 1 testing of a cable. RWC
tests have 2 levels: Level 1 uses the Main Unit and Remote Probe to
perform the Basic Cable Tests (listed below)... plus Speed parameter
testing (10, 100, 1000MB) and Cable Category Testing (CAT 3, 5, 5E,
6). When the Level 1 test is complete, you can choose to continue to
Level 2 and use real data from your own hub, switch or PC to expand
the testing. RW CERTIFY is designed for 4 pair cable only (use BASIC
TEST UTP for other pairings). See List of Functions for a listing of tests.
250 test results can be stored for later printing. Page 13.
BASIC TEST UTP: Move the cursor to BASIC TEST UTP and press
SELECT to test UTP cable for length, opens, shorts, split pairs (plus
distance to these faults) and wire map. BASIC TEST UTP does not
perform Real World Certifi cation. Page 30.
TRACER TONES ON: Move the cursor to TRACER TONES ON and
press SELECT if you wish to energize a cable with a tone (plug the
cable into the Main Unit's RIGHT jack). The Remote Probe detects
the tone at the far end of the cable. This is useful in locating cables in
crowded wiring closets. When selected, tracer tones will stay ON for
one hour. Note: Use the RIGHT jack when tracing unknown cables (it
is protected from accidental high voltage exposure).
RW CERTIFY UTP
BASIC TEST UTP
TRACER TONES ON
EXIT SCROLL SEL
UTP Cable Testing
Main Menu
12
SELECT TEST:
CAT 5/6 UTP