Owner`s manual

9
6.3 On-Screen Display (OSD) F2 SETTINGS
9
6. Operation (continued)
6.3.1 General
F5 – TUNING
As computers are located further away from the KVM switch, the video can become distorted. In the
event you are experiencing poor video quality, the TUNING function can be used to correct it. Press
the[F5]keytodisplaythecurrentlyselectedport,withtheTUNING bar displayed. Use the [←] and
[→]keystomakethenecessaryadjustments.Whenyouarenished,pressthe[Esc]keytogo
back to the OSD. Note: Tuning is performed on a port-by-port basis. You will need to adjust each
port individually.
F6 – MOVE LABEL
By default, the label that displays each ports Port Name appears in the top-center of the screen, but
itcanbemovedanywhereonthescreenthatyouwant.Pressthe[F6]keytodisplaythecurrently
selected port and its label. Use the [↑], [↓], [←] and [→] keys to move the label to the desired
location, and then press the [Esc] key to go back to the OSD. Note: Setting the label location is
performed on one port at a time. You can move the label to different locations on different ports.
F10 – NEW MONITOR – DDC2
In the event that one of the connected computers does not display an image on the console
monitor(e.g.Yougettheerrormessage‘UnabletoDisplayVideoMode’),youmayneedtoupdate
the DDC information being used by the console monitor. To do this, follow the steps below.
1.RemovetheSIUVGAconnectorsfromtheconnectedcomputers,whileleavingthePS/2and/or
USB connectors plugged in.
2.OpentheOSDmainmenuandpressthe[F10]key.TheOSDwillashthemessage“Please
Wait.” When that message disappears, the update is complete.
3.ReconnecttheSIUVGAconnectorstotheconnectedcomputers.Youshouldnowbeableto
display video from all of the remote computers.
Setting Description
Security By default, the Security setting is turned off. To activate the Security setting,
highlight it and press the [Spacebar]. Upon pressing the [Spacebar], you
will be prompted to enter the administrator password in order to change the
Securitysetting.ThedefaultadministratorpasswordisADMIN.Forsecurity
purposes, it is recommended that you update the administrator password
to something unique. (See the Security Settings section for details) Note:
When security is activated, the keyboard hotkey commands are disabled,
leaving the OSD as the only way for you to locally access the connected
computers. Upon pressing the [Shift] [Shift] invocation command, you will
be prompted to enter your password before the OSD can be accessed. The
security settings in this OSD are exclusive to the local console, and do not
affect the remote access security settings.
Pressthe[F2]keytopulluptheOSD SETTINGSscreen.Fromthisscreenyoucanconfigurethe
KVM and add/edit user accounts. The pages that follow describe the sections of the F2 SETTINGS
page, and the settings included in them. Note: When local security is turned on, the KVM
administrator is the only one that can access the F2SETTINGS page.
Highlight the General option and press the [Enter] key to open the GENERAL SETTINGS page. This
page allows you to turn the KVMs local security settings on/off, as well as to configure some of the
basic KVM settings. The table below describes the settings found in this page.
14-03-231-933350.indd 9 3/27/2014 4:38:37 PM