Owners manual

2. Web Conﬁguration Interface

2.4.9 Power Outlets

OnceaPDUisaddedtotheKVMviathePower Devices section, you need to assign a NetCommander IP Target Server port to one of the

portsonaPDUtobeabletoPower Cycle it, or turn its power Off/On. For Target Servers with dual power supplies, you can assign multiple

PDUportstothesameKVMport.Inthiscase,powertobothoftheTargetServerportswillbemanagedatthesametime.

To conﬁgure the power outlets:

1. From the Conﬁguration section, select the Power Outlets tab. The Power Outlets page appears.

2. The Name drop-downlistcontainsallofthePDUsthathavebeenaddedtotheKVM.SelectthedesiredPDU.ThePower Outlets page

populatesaccordingtothenumberofoutletsontheselectedPDU.

3. ForeachoutletonthePDUthathasaTargetServerconnectedtoit,selectfromthecorrespondingServer Name dropdown list the

name of the connected server.

4. Click the Save button at the top of the screen to save your changes.

5. RepeatthesestepsforeachPDUthathasbeenaddedtotheKVM.

14-03-053 93-3261.indd 24 3/14/2014 1:38:03 PM