Owner`s manual
13
Installation continued
1
Make sure that the VGA, Stereo Audio* and RS232 Serial* source is
powered off.
2
(B130-101, B130-101A and B130-101S only) – Connect the VGA and
Stereo Audio* source to the INPUT port(s) on the local unit using a VGA
and Stereo Audio* cable.
3
(B130-101S only) – Connect the included 3.5mm Male to DB9 Female
adapter cable to the 3.5mm INPUT port on the local unit, and then
connect the computer to the adapter using a DB9 cable.
4
(B130-101-U only) – Connect the built-in VGA and USB connectors on
the local unit to the source computer.
5
(B130-101-WP-1 and B130-101A-WP-1 only) – If you wish to connect
a local monitor and speakers*, connect the male end of the included
splitter cable to the source port(s), and then connect one of the female
ends of the splitter cable to the INPUT port(s) on the local unit using a
VGA and Stereo Audio* cable. If you are not connecting a local monitor
and speakers*, connect the source directly to the INPUT port(s) on the
local unit.
6
(Optional) – Connect a local monitor and speakers* to the LOCAL port(s)
on the local unit, or the remaining female connector(s) on your splitter
cable*, using a VGA and Stereo Audio* cable.
Note: The B130-101S comes with a local video port only, and does not contain a
local RS-232 Serial port.
7
Connect the external power supply to the local unit, and then plug it
into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The B130-101-U gets power from
theUSBcablebuilt-intothelocalunit,anddoesn’trequireexternalpower
supplies.
8
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the local unit to
theRJ45INPUT port on the remote unit.
9
(B130-101-U only) – Connect the built-in VGA connector on the remote
unit to the VGA port on a monitor.
*If this is a feature of your extender kit.
201105276 933064-EN.indd 13 6/17/2011 12:24:18 PM