Owner`s manual

21
Installation continued
If you are not connecting any additional remote/repeater units, proceed to
step 12.
8
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the first remote/
repeaterunittotheRJ45INPUT port on a second remote/repeater unit.
Note: If starting with a B130-101 or B130-101A, a remote/repeater unit
(B132-110 or B132-110A) must be added in between the local and remote units
that come with the kit.
9
Ontheremote/repeaterunityoujustadded,connectamonitorand
speakers* to the OUTPUT port(s) using a VGA Video and Stereo Audio*
cable.
10
Connect the external power supply to the remote/repeater unit, and then
plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The Red power LED and the Green
RJ45LEDsilluminatetoindicatetheunitisreceivingpower.
11
Repeat steps 8 through 10 for each additional unit you are connecting,
with no more than 4 in a chain. The last remote unit in an extender/
repeater installation should be a standard B132-100-1, B132-100-
WP-1, B132-100A or B132-100A-WP-1 receiver. When starting with a
B130-101 or B130-101A kit, the included remote receiver can be the
last unit in the chain.
12
Turn on the power to the connected monitors and speakers.*
13
Turn on the power to the VGA Video and Stereo Audio* source. The
OrangeRJ45LEDswillilluminatetoindicatethattheunitsarereceivinga
signal from the source.
14
Ifnecessary,usetheincludedscrewdrivertoadjusttheEqualizationand
Gain settings on the remote/repeater units to improve the video image.
*If this is a feature of your extender kit.
201105276 933064-EN.indd 21 6/17/2011 12:24:20 PM