Owner`s manual

23
Installation continued
4. To achieve maximum distance and performance, 24Awg solid wire Cat5e/6 cable
must be used. The use of stranded wire Cat5e/6 cable, or cable with a gauge (AWG)
size higher than 24Awg, will result in shorter extension distance. All Tripp Lite N202-
Series cables are made with 24Awg solid wire cabling. Tripp Lite N022-01K-GY
(Cat5e) and N222-01K-GY (Cat6) are 24Awg solid wire bulk cables. For optimal
image quality between 500 and 1,000 ft., use Zero-Skew cable, such as
Tripp Lite P524-01K.
5. To achieve maximum distance and performance, it is recommended that you use
Tripp Lite P502-Seriess VGA Video or P504-Series VGA + Audio cables with RGB
coax.
1
Make sure that the VGA Video and Stereo Audio* source is powered off.
2
Connect the VGA Video and Stereo Audio* source to the INPUT port(s) on
the local unit.
3
(Optional – B132-004-1 and B132-004A only)–Connectalocal
monitor and speakers* to the LOCAL port(s) on the local unit using a VGA
Video and Stereo Audio* cable.
4
Connect the external power supply to the local unit, and then plug it
into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The Red power LED and the Green
RJ45LEDswillilluminatetoindicatetheunitisreceivingpower.
5
UsingCat5e/6cable,connectanavailableRJ45OUTPUT port on the local
unittotheRJ45INPUT port on the remote/repeater unit. (B132-110 or
B132-110A)
6
Connect a monitor and speakers* to the OUTPUT port(s) on the remote/
repeater unit using a VGA Video and Stereo Audio* cable.
7
Connect the external power supply to the remote/repeater unit, and then
plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The Red power LED and the Green
RJ45LEDsilluminatetoindicatetheunitisreceivingpower.
If you are not connecting any additional remote/repeater units, proceed to
step 12.
*If this is a feature of your extender kit.
201105276 933064-EN.indd 23 6/17/2011 12:24:20 PM