Owner`s manual

Installation continued

*If this is a feature of your extender kit.

2. A 1024 x 768 (60Hz) signal can be extended up to 1,000 ft. between the local

transmitter and the ﬁrst remote/repeater unit in the installation. Up to an additional

1,000 ft. can be placed in between the ﬁrst remote/repeater unit and the last display

in the installation, for a maximum extension distance of 2,000 ft. Up to 4 remote

units (3 remote/repeaters and 1 receiver) can be connected together to transmit a

signal to up to 4 points in a 2,000 ft. chain.

3. Test to make sure the entire installation works properly before pulling cables through

ceilings/walls.

4. To achieve maximum distance and performance, 24Awg solid wire Cat5e/6 cable

must be used. The use of stranded wire Cat5e/6 cable, or cable with a gauge (AWG)

size higher than 24Awg, will result in shorter extension distance. All Tripp Lite N202-

Series cables are made with 24Awg solid wire cabling. Tripp Lite N022-01K-GY

(Cat5e) and N222-01K-GY (Cat6) are 24Awg solid wire bulk cables. For optimal

image quality between 500 and 1,000 ft., use Zero-Skew cable, such as

Tripp Lite P524-01K.

5. To achieve maximum distance and performance, it is recommended that you use

Tripp Lite P502-Seriess VGA Video or P504-Series VGA + Audio cables with RGB

coax.

Make sure that the VGA Video and Stereo Audio* source is powered off.

Connect the VGA Video and Stereo Audio* source to the INPUT port(s) on

the local unit using a VGA Video and Stereo Audio* cable.

Using the included daisychain cable, connect the LOCAL port(s) on the

local unit to the INPUT ports on a second level local unit.

Note: A standard VGA cable can be used to increase the distance between units

with no more than 6 ft. between.

Repeat step 3 for each additional local unit you are adding to the

daisychain, with no more than 6 local units in the entire installation.

(Optional) –Connectalocalmonitorandspeakers*totheLOCAL port(s)

of the last local unit in the daisychain using a VGA Video and Stereo

Audio* cable.

Connect the external power supply to the ﬁrst local unit in the installation,

and then plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit

(PDU) or Uninterruptible Power Supply (UPS). The Red power LED and the

GreenRJ45LEDswillilluminatetoindicatetheunitisreceivingpower.

201105276 933064-EN.indd 26 6/17/2011 12:24:21 PM