Owner`s manual

27
Installation continued
7
Repeat step 6 for each additional local unit in the installation.
8
UsingCat5e/6cable,connectanavailableRJ45OUTPUT port on the local
unittotheRJ45INPUTportontheremote/repeaterunit.(B132-110or
B132-110A)
9
Connect a monitor and speakers* to the OUTPUT port(s) on the remote/
repeater unit using a VGA Video and Stereo Audio* cable.
10
Connect the external power supply to the remote/repeater unit, and then
plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The Red power LED and the Green
RJ45LEDsilluminatetoindicatetheunitisreceivingpower.
If you are not connecting any additional remote/repeater units, proceed to
step 15.
11
UsingCat5e/6cable,connecttheRJ45OUTPUT port on the first remote/
repeaterunittotheRJ45INPUT port on a second remote/repeater unit.
12
Ontheremote/repeaterunityoujustadded,connectamonitorand
speakers* to the OUTPUT port(s) using a VGA Video and Stereo Audio*
cable.
13
Connect the external power supply to the remote/repeater unit, and then
plug it into a Tripp Lite Surge Suppressor, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The Red power LED and the Green
RJ45LEDsilluminatetoindicatetheunitisreceivingpower.
14
Repeat steps 11 through 13 for each additional unit you are connecting,
with no more than 4 in a chain. The last remote unit in the installation
should be a standard B132-100-1, B132-100-WP-1, B132-100A or
B132-100A-WP-1 receiver.
15
Repeat steps 8 through 14 for each additional local unit port that you are
adding remote/repeater units to, with no more than 4 levels per port.
16
Turn on the power to the connected monitors and speakers.*
17
Turn on the power to the VGA Video and Stereo Audio* source. The
OrangeRJ45LEDswillilluminatetoindicatethattheunitsarereceivinga
signal from the source.
18
Ifnecessary,usetheincludedscrewdrivertoadjusttheEqualizationand
Gain settings on the remote/repeater units to improve the video image.
*If this is a feature of your extender kit.
201105276 933064-EN.indd 27 6/17/2011 12:24:21 PM