Owner`s manual

DVI SOURCE
B140-1A1-WP LOCAL
TRANSMITTER
B140-1A1-WP REMOTE
RECEIVER
B140-110
REMOTE
REPEATER
B140-110
REMOTE
REPEATER
B140-110
REMOTE
REPEATER
Up to 175 ft. at 1024 x 768 (60Hz)
Up to 125 ft. at 1920 x 1080 (60Hz)
Up to 175 ft. at 1024 x 768 (60Hz)
Up to 125 ft. at 1920 x 1080 (60Hz)
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
11
Extender Kit with Remote/Repeater
Installation (B140-101X and B140-1A1-WP extender kits only)
Notes:
1. Test to make sure the entire installation works properly before pulling
cables through ceilings/walls.
2. To achieve maximum distance and performance, use 24 AWG solid
wire Cat5e/6 cable. Using stranded wire Cat5e/6 cable, or cable
with a gauge (AWG) size higher than 24 AWG, will result in shorter
extension distance. All Tripp Lite N202-Series Cat6 cables are made
with 24 AWG solid wire cabling.
3. The installation diagram shows a B140-1A1-WP. The B140-101X
installation is the same, except its local unit does not require power.
1
Make sure the DVI source is powered OFF.
2
Connect the built-in DVI connector on the B140-101X local unit to
theDVIsource;or,connecttheDVIsourcetotheINPUTportonthe
B140-1A1-WPlocalunitusingaTrippLiteP561-SeriesDVI-DSingle
Link Cable.
3
B140-1A1-WP only: Connect the external power supply to the local
unit and plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The
GreenPowerLEDwillilluminate.
201110026-93-3094-EN.indd 11 11/3/2011 11:37:09 AM