Owner`s manual

13
11
UsingCat5e/6cable,connecttheRJ45OUTPUTportonthelast
remote/repeaterunittotheRJ45INPUTportoftheB140-101Xor
B140-1A1-WP remote receiver unit.
12
Connect a monitor to the DVI OUTPUT port on the remote receiver
unitusingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
13
Connect the external power supply to the remote receiver unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
RJ45LEDontheB140-101Xremotereceiver,ortheGreenPower
LED on the B140-1A1-WP remote wallplate, illuminates to indicate
the unit is receiving power from the external power supply.
14
Turn on the power to the DVI source. The Orange LEDs on the
B140-1A1-WP units illuminate to indicate a signal is being received
fromthesource.TheOrangeRJ45LEDsontheB140-101Xand
B140-110 units illuminates to indicate a signal is being received
from the source.
15
If necessary, use the Equalization control on the remote/repeater
unit(s) and remote receiver unit to adjust the video image. Note: An
improper Equalization setting can cause the monitor not to display
a picture at all. Try each Equalization setting until an acceptable
picture is displayed.
Extender Kit with Remote/Repeater
Installation (B140-101X and B140-1A1-WP extender kits only)
201110026-93-3094-EN.indd 13 11/3/2011 11:37:09 AM