Owner`s manual

15
Standard Extender/Splitter Installation
1
Make sure the DVI source is powered OFF.
2
Connect the DVI source to the DVI port on the B140-002 or
B140-004labeledINPUTusingaTrippLiteP561-SeriesDVI-D
Single-Link Cable.
3
Optional for B140-004: Connect a DVI monitor to the DVI port on
theB140-004markedLOCALusingaTrippLiteP561-SeriesDVI-D
Single-Link Cable.
4
Connect the external power supply to the B140-002 or B140-004
local unit and plug it into a Tripp Lite Surge Suppressor, PDU or
UPS.TheGreenRJ45LEDsandRedPowerLEDontheB140-004
will illuminate to indicate power is being received from the external
powersupply.TheGreenRJ45LEDsontheB140-002willilluminate
to indicate power is being received from the external power supply.
5
UsingCat5e/6cable,connectoneoftheRJ45outputportsonthe
localunittotheRJ45inputportontheB140-1P0,B140-1A0,
B140-1P0-WP-1 or B140-1A0-WP-1 remote unit.
6
Repeatstep5foreachadditionalremoteunityouareconnecting.
7
B140-1A0 and B140-1A0-WP-1 only: Connect the external
power supply to the B140-1A0 or B140-1A0-WP-1 and plug it into
aTrippLiteSurgeSuppressor,PDUorUPS.TheGreenRJ45LED
ontheB140-1A0andtheGreenLEDontheB140-1A0-WP-1will
illuminate to indicate that the unit is receiving power.
8
Repeat step 7 for each additional B140-1A0 or B140-1A0-WP-1 in
the installation.
201110026-93-3094-EN.indd 15 11/3/2011 11:37:10 AM