Owner`s manual

22
Extender/Splitter Daisy-Chain Installation
12
ConnecttheB140-1P0DVI-DSingle-LinkConnectortothemonitor;
or, connect the B140-1P0-WP-1, B140-1A0 or B140-1A0-WP-1 to
themonitorusingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
TheGreenRJ45LEDontheB140-1P0andtheGreenLEDonthe
B140-1P0-WP-1 illuminate to indicate the unit is receiving power
from the monitor.
13
Repeat step 12 for each additional monitor you are connecting.
14
TurnonthepowertotheDVIsource.TheOrangeRJ45LEDs
illuminate on the B140-004 and B140-1A0 and the Orange LED
illuminates on the B140-1A0-WP-1 to indicate the unit is receiving a
signal from the source. The screen should now be displayed on the
connected monitors.
15
If necessary, use the Equalization control on the B140-1A0 or
B140-1A0-WP-1 to adjust the video image. Note: An improper
Equalization setting can cause the monitor not to display a picture
at all. Try each Equalization setting until an acceptable image is
displayed.
Extender/Splitter Daisy-Chain with Remote/
Repeater Installation (B140-004 extender/splitter,
and B140-1A0 and B140-1A0-WP remote receivers only)
Notes:
1. Test to make sure the entire installation works properly before pulling
cables through ceilings/walls.
2. To achieve maximum distance and performance, use 24 AWG solid
wire Cat5e/6 cable. Using stranded wire Cat5e/6 cable, or cable
with a gauge (AWG) size higher than 24 AWG, will result in shorter
extension distance. All Tripp Lite N202-Series Cat6 cables are made
with 24 AWG solid wire cabling.
201110026-93-3094-EN.indd 22 11/3/2011 11:37:13 AM