Owner`s manual

19
Extender/Splitter with Remote/Repeater Installation
(B140-1A0 and B140-1A0-WP-1 remote receiver units only)
10
Connect the external power supply to the remote/repeater unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
PowerLEDandtheGreenRJ45LEDsilluminatetoindicatetheunit
is receiving power.
11
To add a third remote/repeater unit, repeat steps 8 through 10. To
nishyourinstallationwithaB140-1A0orB140-1A0-WP-1remote
receiver unit, proceed to step 12.
12
UsingCat5e/6cable,connecttheRJ45OUTPUTportonthelast
remote/repeaterunittotheRJ45INPUTportonaB140-1A0or
B140-1A0-WP-1 remote receiver unit.
13
Connect a monitor to the DVI OUTPUT port on the remote receiver
unitusingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
14
Connect the external power supply to the remote receiver unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
RJ45LEDsontheB140-1A0andtheGreenLEDontheB140-1A0-
WP-1 illuminate to indicate that the unit is receiving power.
15
Repeatsteps5through14foreachadditionalRJ45outputporton
the local transmitter unit.
16
TurnonthepowertotheDVIsource.TheOrangeRJ45LEDson
the local transmitter, remote/repeater and B140-1A0 illuminate
to indicate a signal is being received from the source. The Orange
LED on the B140-1A0-WP-1 illuminates to indicate a signal is being
received from the source.
17
If necessary, use the Equalization control on the remote/repeater
unit(s) and remote receiver unit to adjust the video image. Note: An
improper Equalization setting can cause the monitor not to display
a picture at all. Try each Equalization setting until an acceptable
picture is displayed.
201110026-93-3094-EN.indd 19 11/3/2011 11:37:12 AM