Owner`s manual

21
Extender/Splitter Daisy-Chain Installation
1
Make sure the DVI source is powered OFF.
2
Connect the DVI source to the DVI port on the B140-004 labeled
INPUTusingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
3
Connect the external power supply to the B140-004 local unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
RJ45LEDsandRedPowerLEDwillilluminatetoindicatepoweris
being received from the external power supply.
4
Using the included DVI daisy-chain cable, connect the OUTPUT
DVIportontherstB140-004totheINPUTDVIportonasecond
B140-004.
5
Connect the external power supply to the B140-004 local unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
RJ45LEDsandRedPowerLEDwillilluminatetoindicatepoweris
being received from the external power supply.
6
Repeatsteps4and5ifyouareconnectingathirdB140-004.
7
Optional: Connect a DVI monitor to the OUTPUT DVI port on the last
B140-004usingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
8
UsingCat5e/6cable,connectoneoftheRJ45outputportsona
localunittotheRJ45inputportonaB140-1P0,B140-1A0,
B140-1P0-WP-1 or B140-1A0-WP-1 remote unit.
9
Repeat step 8 for each additional remote unit you are connecting.
10
B140-1A0 and B140-1A0-WP-1 only: Connect the external power
supply to the B140-1A0 or B140-1A0-WP-1, and plug it into a
TrippLiteSurgeSuppressor,PDUorUPS.TheGreenRJ45LEDs
ontheB140-1A0andtheGreenLEDontheB140-1A0-WP-1
illuminate to indicate the unit is receiving power.
11
Repeat step 10 for each additional B140-1A0 or B140-1A0-WP-1 in
the installation.
201110026-93-3094-EN.indd 21 11/3/2011 11:37:13 AM