Owner`s manual

24
Extender/Splitter Daisy-Chain with Remote/
Repeater Installation (B140-004 extender/splitter,
and B140-1A0 and B140-1A0-WP remote receivers only)
1
Make sure the DVI source is powered OFF.
2
ConnecttheDVIsourcetotheINPUTportontheB140-004usinga
TrippLiteP561-SeriesDVI-DSingle-LinkCable.
3
ConnecttheLOCALportontheB140-004totheINPUTportona
second B140-004 using the included 1-ft. DVI daisy-chain cable.
4
Repeat step 3 if you want to connect a third B140-004.
5
ConnecttheexternalpowersupplytotherstB140-004inthe
daisy-chain and plug it into a Tripp Lite Surge Suppressor, PDU or
UPS.TheGreenRJ45LEDsandtheRedPowerLEDontheB140-
004 will illuminate to indicate power is being received from the
external power supply.
6
Repeatstep5foreachadditionalB140-004inthedaisy-chain.
7
Optional: Connect a DVI monitor to the OUTPUT DVI port on the last
B140-004usingaTrippLiteP561-SeriesDVI-DSingle-Linkcable.
8
UsingCat5e/6cable,connectoneoftheRJ45outputportsonthe
localunittotheRJ45inputportontheB140-110remote/repeater
unit.
9
Connect a monitor to the DVI OUTPUT port on the remote/repeater
unitusingaTrippLiteP561-SeriesDVI-DSingle-LinkCable.
10
Connect the external power supply to the remote/repeater unit and
plugitintoaTrippLiteSurgeSuppressor,PDUorUPS.TheGreen
PowerLEDandtheGreenRJ45LEDsilluminatetoindicatetheunit
is receiving power.
201110026-93-3094-EN.indd 24 11/3/2011 11:37:16 AM