Owners manual

13
3. In the VLAN Management section, create a new VLAN for each
transmitter in the installation. The transmitter port number should
always be the first number in the VLAN, followed by the port numbers
(separated by commas) of all receiver units that will be transmitting
audio/video to and from the selected transmitter. The screenshot below
shows VLAN’s for four transmitters (VLAN0002 through VLAN0005).
VLAN0002 represents the transmitter connected to port 1, the audio/
video of which is transmitted to the receivers connected to ports 7 and
8. Similarly, VLAN0003 represents the transmitter connected to port 2,
whose audio/video is transmitted to receivers connected to ports 9 and
10.
4. To switch the source of the audio/video on a receiver, go to and edit the
VLAN of the associated transmitters to add/remove the desired ports.
5. As more transmitters and receivers get added to the installation,
simply add additional VLANs for the new transmitters and add the new
receivers to the VLANs of the desired transmitters.
Operation of Point-to-Multipoint
Installation – Managed Switch with IGMP
17-02-096-93360B-EN.indd 13 2/13/2017 4:56:06 PM