SNMP Owner's Manual

Tripp Lite

Configuration 13

To assign the IP address of SNMP Solo, the gateway, and the

network, type at the prompt:

space

, the IP address of the SNMP Solo,

space

MASK_BIT_COUNT,

space

, the IP address of the gateway.

The MASK_BIT_COUNT is used to indicate a mask for your

gateway. The meaning of the numbers used in the

MASK_BIT_COUNT will change based on the class of network

you have. A Class A network has 24 options, a class B network

has 16 options and a Class C has 8 options. The SNMP Solo

automatically discovers the type of network in use from the first

three digits of the IP address. The MASK_BIT_COUNT and the

corresponding mask for each type of network is shown below.

Class A Network

0 255.000.000.000 12 255.255.240.000

1 255.128.000.000 13 255.255.248.000

2 255.192.000.000 14 255.255.252.000

3 255.224.000.000 15 255.255.254.000

4 255.240.000.000 16 255.255.255.000

5 255.248.000.000 17 255.255.255.128

6 255.252.000.000 18 255.255.255.192

7 255.254.000.000 19 255.255.255.224

8 255.255.000.000 20 255.255.255.240

9 255.255.128.000 21 255.255.255.248

10 255.255.192.000 22 255.255.255.252

11 255.255.224.000 23 255.255.255.254