Owners manual

5. Enclosure Configuration

5.1 Door Locks

5.2 Cable Access and Management

The front door contains a lock that is accessible with the included keys.

Before attempting to close and lock the front door, first ensure that the top panel’s notches are

secured within the rear panel slots. Then gently place the top panel over the enclosure frame.

Once the top panel is secured, swing the front door up. The front door will overlap the top panel

and the enclosure’s left and right sides. Use an included key to lock the door.

The rear and bottom of the enclosure has two circular holes per side for cable access and

management. To uncover a cable access hole, simply pop out the desired cap.

Before installation, plan the location and arrangement of components within the enclosure. Make sure all mounting rails are reversed or adjusted for

depth, depending on your equipment configuration.

5.3 Mounting Rails

The enclosure comes with mounting rails with square holes for 19” rackmount-compatible DVR

equipment. To install your DVR, use the included cage nuts and other device hardware (see 7.1

Installing or Removing Cage Nuts section for more information). Warning: Be sure to have

the enclosure securely mounted to the wall, tabletop or floor before mounting any

equipment inside. Also be sure to have all the right adjustments on your rails before

mounting equipment (see Adjusting Mounting Rail Depth section for more information).