User's Manual

1. If the inserted MIC is the only MIC currently synced to that BASE, the MIC shall stop
transmitting audio and shall transmit a data packet with the security code and the turn off
command to the BASE unit to stop recording.
2. If the inserted MIC is one of two MICs currently synced to that BASE and it is in an active
record session, the MIC shall stop transmitting audio and shall transmit a data packet with
the security code and the turn off command to the BASE unit to stop recording. The BASE
shall stop the record session with that MIC, but not the other MIC if it is also active.
3. If the inserted MIC is not one that is currently synced to that BASE, sync with that MIC shall
be held off until the record session is ended either by manually turning off the record
session or by inserting the one or both active MICs into the BASE.
General Specifications:
Operating Frequency Range 902 – 928 MHz
Operating Voltage 9 to 15 VDC
Frequency Hopping Sequences 32,768
Frequencies per Sequence 16
Audio Output 250 mV RMS
Range 1000 ft
FCC Information:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
An FCC license is not required for operation of this device.
The ICOP Digital 20/20-WBASE must be installed by a qualified professional using one of
the two antennas supplied with the product:
Rubber Duck Antenna ICOP PN 600-00143
Roof Mount Antenna ICOP PN 600-00142
Unauthorized modifications to this equipment could void the user’s authority to operate this
equipment.