User's Manual

4. If the inserted MIC is the only MIC currently synced to that BASE, the MIC shall stop
transmitting audio and shall transmit a data packet with the security code and the turn off
command to the BASE unit to stop recording.
5. If the inserted MIC is one of two MICs currently synced to that BASE and it is in an active
record session, the MIC shall stop transmitting audio and shall transmit a data packet with
the security code and the turn off command to the BASE unit to stop recording. The BASE
shall stop the record session with that MIC, but not the other MIC if it is also active.
6. If the inserted MIC is not one that is currently synced to that BASE, sync with that MIC shall
be held off until the record session is ended either by manually turning off the record
session or by inserting the one or both active MICs into the BASE.
Buttons and Modes of Operation
The MIC Transceiver Wireless Microphone can be switched between three modes of
operation:
1) TRANSMIT Mode
In TRANSMIT mode the Wireless Microphone is fully operational and is transmitting
and receiving continuously. Audio transmitted from the microphone can be recorded
on the DVR. To select TRANSMIT mode, push the record (REC) button on the MIC
Transceiver. Transmit mode can also be selected from the DVR. The MIC Transceiver
will indicate that it is transmitting audio by lighting the Green LED indicator. The MIC
Transceiver will indicate that it has moved out of range of the BASE Transceiver by
turning off the Green LED and lighting the Yellow LED indicator.
2) HELP Mode
In HELP mode the Wireless Microphone is fully operational and is transmitting and
receiving continuously. In addition, a signal is activated to the DVR to indicate that the
user has pressed the HELP button. To select HELP mode, push the HELP button on
the front of the MIC Transceiver. The LEDs will continuously repeats the pattern
green/red/yellow/red separated by longer periods of green or yellow range status
indication.
After every 7
th
repetition of the green/red/yellow/red pattern, the red LED quickly blinks
1 or 2 times to indicate a low battery during the green or yellow range status indication.
Battery 25% 1 Red Blink
Battery 50% 2 Red Blinks
3) On-STANDBY Mode
In STANDBY mode, the transmitter is turned off and the unit can only receive. Select
STANDBY mode by pushing the record button on the MIC Transceiver while in
TRANSMIT mode or HELP mode. STANDBY cannot be selected from the in-dash unit.
The green LED blinks ON every 6 seconds to indicate RHT is able to transmit and
receive communications. The red LED blinks 1 or 2 times every 6 seconds to indicate
a low battery condition.
Battery 25% 1 Red Blink
Battery 50% 2 Red Blinks
4) OFF
When OFF, the MIC Transceiver cannot transmit or receive. The MIC Transceiver can
be turned OFF by pressing and holding the power button for 1 second until the green