Operation Manual

18
Winding of the bobbins
Figure 1. Place a yarn pin on the spool pin (no.1).
Guide the thread through the winding thread guide (no.2) to the empty bobbin.
Place the bobbin winding pin (no.18) on the machine.
Wind the thread several times clockwise to the empty bobbin and place it on the
bobbin winding pin (no.18).
Figure 2. Turn the hand wheel (no. 11) clockwise until the thread is tightened.
Start electric winding by pressing the foot control.
When the bobbin is full, release the foot pedal, cut the thread, then remove bobbin
Reverse sewing.
Reverse sewing is suitable for fastening the seam when start seam or finish seam to avoid
stitches loose. Stop the machine firstly, then press the reserve sewing lever (no.10), the
machine can sew reverse. Release the reserve button, the machine can recover to sew
forward. The reverse trace shouldn’t beyound 5 cm.
19
Release of the fabric
Set the needle at the highest position by turning the hand wheel (no. 11) anticlockwise.
Raise the presser foot (no. 8) and remove the fabric backwards.
Cut the threads by using the thread cutter (no. 6) at the side of the machine.
Straight and other stitching
There are three kinds of straight stitches for your choise. Turn the pattern selector (no. 4) to
the one you need. Set the needle at the highest position by turning hand wheel anticlockwise.
Gently pull both threads (about 10 cm) towards rear, raise the presser foot (no. 8), place the
fabric under the presser foot. Gently press down the foot pedal (no. 16) to start sewing. Guide
fabric gently by hand. Stop the needle in its top position, and thread can be pulled out easily.
Raise the presser foot (no. 8) and remove the fabric. This is for all the patterns of your choise.
Notice:
When turning the pattern selector, assure the needle tip is at the upper position, otherwise it
will be bent or damaged or fail to sewing.
When selecting the pattern, set the position correctly, otherwise it will hurt the needle or sew
over the the selected stitch trace. It will be different from the selected pattern.
Thread tension adjustment
For a correct stitch the upper and the lower thread should be even. By turning the thread
tension dial the upper thread can be switched from the left to the right. Use this dial to get the
two threads even.