Installation Manual
Table Of Contents
- List of Figures
- List of Tables
- About This Book
- Warnings and Safety Guidelines
- Avertissements et consignes de sécurité
- Conventions
- Risque de lésions corporelles provoquées par la décharge électrique
- Risque de lésions corporelles provoquées par les câbles à fibres optiques
- Risque de lésions corporelles provoquées par l’exposition de l’énergie radiofréquences
- Autres risques des lésions corporelles
- Risque d’interruption de service
- Autres mises en garde
- Installation Overview
- Staging Procedure
- Installation Procedures
- Commissioning Procedures
- Removing an IFU
- IFU Test Results
- Index
Installing IFU Components
28 GHz Fast Ethernet IFU Installation (9/17/99) - R0.1 3-3
CONFIDENTIAL & PROPRIETARY
D
O
N
O
T
C
O
P
Y
Installing IFU Components
This section describes how to:
n
Mount the IFU bracket
n
Install the power cables
n
Install the alarm cables
n
Install fiber optic cables
Mounting the IFU Bracket
Using approved engineering methods, mount the IFU bracket in the location
specified in the site engineering folder (see Figure 3-1 for typical wall
mounting and Figure 3-2 for a typical pole mounting).
Figure 3-1. Example of IFU Bracket Attached to Wall
3
1
4
5
6
4
5
2
MOUNTING SURFACE
LEGEND
ITEM
1
2
3
4
5
6
DESCRIPTION
IFU M0UNTING BRACKET
THREADED ROD*
FLAT WASHER
SPLIT RING WASHER
NUT
LARGE FLATWASHER
QTY
1
4
4
8
8
4
* THREADED ROD LENGTH
IS DETERMINED BY WALL
THICKNESS PLUS 2.5 INCHES
102 MM
4.0 IN
276 MM
10.9 IN
BRACKET HOLE PATTERN
ALLOW 11MM/0.5 IN.
FOR CLEARANCE
(Not to Scale)