Installation Manual
Table Of Contents
- List of Figures
- List of Tables
- About This Book
- Warnings and Safety Guidelines
- Avertissements et consignes de sécurité
- Conventions
- Risque de lésions corporelles provoquées par la décharge électrique
- Risque de lésions corporelles provoquées par les câbles à fibres optiques
- Risque de lésions corporelles provoquées par l’exposition de l’énergie radiofréquences
- Autres risques des lésions corporelles
- Risque d’interruption de service
- Autres mises en garde
- Installation Overview
- Staging Procedure
- Installation Procedures
- Commissioning Procedures
- Removing an IFU
- IFU Test Results
- Index
Commissioning Procedures
4-10 © 1999 Triton Network Systems, Inc. All Rights Reserved.
CONFIDENTIAL & PROPRIETARY
D
O
N
O
T
C
O
P
Y
3 Connect the SmartBits™ test set from 100BaseFX port 4 to IFU Beta
100BaseFX Payload port on the patch panel with the MT-RJ to SC fiber
adapters.
4 Turn on power to the SmartBits™ test set.
5 On the laptop, open the SmartApplication™ program.
6 Select File>Open and then click Building Payload Test (file provided by
Triton Network Systems).
7 Select Run then click Packet Loss to run the Packet Loss tests.
8 Record the results of 64, 76, 128, 164, 512, 1024, and 1518 byte packet
tests in Fast Ethernet Payload Test on page A-4.
9 Stop all tests, disconnect the test equipment, and return the equipment to
its previous state.
Repeat this procedure for each IFU site.