Instructions / Assembly

Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 2
Wire Shelf Installation (See image below) make sure that brackets attach over the top of the wire shelf
with flat surface up. Attach left and right lock-on hanging brackets over each side. Wire shelf should be
installed level and in the inside slot positions of each hang rail spaced 30-3/8” apart. If accidental
binding occurs use soft rubber mallet to help remove accessory and protect paint. To attach and detach
push unit upward into the rail slots and push in or pull out at about a 45 degree angle.
Assemble with hang rail slotted ends
to outside. Make sure notches are at
the far end of assembled hang rail
and space the hang rails on the Top
Track 30-3/8” apart measured inside
(between) the hang rails. The vertical
rails can be mounted to the wall.
You can use the provided drywall
anchors, the molly bolts or the wood
screws if you are mounting to the
studs.