Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1 INLBD2101
Read all instructions completely before installing. Should you have any questions about your installation,
please call Customer Service at 440-248-5480
 These rugged steel tool boards can be easily and quickly positioned to conform to your storage
requirements.
 Boards can be positioned side by side or above one another in vertical and horizontal mounting
positions.
 Additional boards and hooks can be added to your system as your needs continue to grow.
 LocBoards fasten directly to concrete, solid wood and hollow wall structures without the use of
furring strips. (Mounting hardware not included.)
 LocBoards are designed with internal ribbed support members that not only keep mounting
hardware hidden from sight but also add to the board’s structural integrity and holding power.
LocBoard™ Installation:
Hardware need for installation: (NOTE DO NOT USE Tapered Head Screws.)
1. For hollow or concrete block wall: Quantity=12 Each #8- 2” long Phillips pan head machine screws and
#8 plastic commercial grade wall anchors. Head diameter size of screws should not exceed .35” in
order to fit through square holes in front of boards.
2. For wood stud or wood headers: Use #8-2” long wood screws with Phillips pan heads
Tools needed for Installation:
Level, Marker, 7/32” standard or masonry drill bit, 7/64” std bit for wood studs, #2 Phillips head screw driver,
power drill.
1. Select wall location for your LocBoards and the desired vertical or horizontal mounting pattern you
wish to mount in. When selecting a location for mounting always make sure that mounting locations
do not fall in line with, are adjacent to, or interfere with any internal or external electrical wiring, wall
mounted or built-in electrical appliances, heaters, gas lines, ductwork or plumbing inside of wall, or
are located on the opposite side of any wall surface from where you are mounting. If you are unsure,
please consult a professional before proceeding with installation.
2. (Using Images on Back) There are three screw holes in each mounting flange on the back of your
LocBoard that are accessible through the square holes on the front.
3. Place 1 LocBoard with mounting flanges flat against wall surface. While using a level to make sure
your board is straight and squared, looking through the square holes on the front of the board, mark
the centers of all 6 screw holes onto your wall surface. Note: Installation for first board should be
completed before marking mounting holes for the second board.
4. Pre-drill holes for #8 wall anchors marked in Step 3 using 7/32" standard or masonry drill bit
depending on wall surface. If you hit a wood stud stop drilling and using a 7/64” drill bit create a
pilot hole for the wood screw Note: Avoid over drilling holes. (Plastic wall anchors should fit snug.)
5. Insert plastic wall anchors in each hole drilled in Step 4 except where you drilled 7/64” pilot hole for
wood stud.
6. Align mounting holes in wall surface with screw holes in back flanges. Insert wood screws through
the front square opening and into pre-installed plastic wall anchors. Tighten all screws. The head of
each screw should not be visible and will be tight against inside surface of each mounting flange.
7. Repeat Steps 2-6 for second LocBoard installation.
LB1-B, T, W - (2) 24” x 24” x 9/16” LocBoard® Pegboards