Instructions / Assembly

Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
Review Carton Contents: (1 Box Makes Up This Kit):
• 2 Pcs Stainless Steel LocBoard Pegboard 24" x 42.5"
• Mounting Hardware
• Boards can be positioned side by side or in separate location in vertical or horizontal mounting
positions.
• Pegboards fasten directly to concrete, solid wood and hollow wall structures without the use of
furring strips.
• If installing to bare studs you will need to install wood headers before completing installation.
Stainless Steel LocBoard™ Installation:
1. (IMPORTANT!) Select wall location for your Stainless Steel LocBoards and the desired vertical or
horizontal mounting pattern you wish to mount in. When selecting a location for mounting
always make sure that mounting locations do not fall in line with, are adjacent to or interfere
with any internal or external electrical wiring, wall mounted or built-in electrical appliances,
heaters, gas lines, ductwork or plumbing inside of wall, or are located on the opposite side of
any wall surface from where you are mounting. If you are unsure, please consult a professional
before proceeding with installation.
2. There are twelve screw holes in on the back of your Stainless Steel LocBoard that are accessible
through the square holes on the front (see images on back).
3. Place one Stainless Steel LocBoard flat against wall surface, while using a level to make sure your
board is straight and squared. Once you have marked a minimum of 2 mount hole locations per
bracket using figure 1-1: You are now ready to pre-drill all holes in accordance to the
specifications called out by the manufacturer of mounting hardware to be used.
4. Note: Installation for first board should be completed before marking mounting holes for the
second board.
5. Pre-drill holes for #8 wall anchors marked in Step 3 using 7/32" standard or masonry drill bit
depending on wall surface. If you hit a wood stud stop drilling and using a 7/64” drill bit create a
pilot hole for the wood screw, Note: avoid over-drilling holes. (Plastic wall anchors should fit
snug.)
6. Insert plastic wall anchors in each hole drilled in Step 4 except where you drilled 7/64” pilot hole
for wood stud.
7. Align mounting holes in wall surface with screw holes in back of Stainless Steel LocBoard. Insert
wood screws through the front square opening and into pre-installed plastic wall anchors.
Tighten all screws. The head of each screw should not be visible and will be tight against inside
surface of each mounting flange.
8. Repeat Steps 2-6 for second Stainless Steel LocBoard installation.
LB2-S - (2) 24” x 42-1/2” x 9/16” Stainless Steel LocBoard®(s)