Instructions / Assembly

Installation & Assembly Instructions
Please contact Customer Service with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1
Read all instructions completely before installing. Should you have any questions about your installation,
please call Customer Service at 440-248-5480.
Inspect all components before starting assembly.
Report any missing parts and/or damaged goods within 5 days from receipt.
Tool Cart Parts Inventory
(1) Aluminum Bottom Tray
(1) Top Rail with ends bent upwards
(1) Cart Handle
(2) 3” Fixed Casters
(2) 3” Swivel Casters
(4) LocBoard Steel Pegboard w/ square holes 18” X 36” (B=Blue and T=Tan)
(16) 5/16” -20 x 3/4” Truss Head Bolts (For Casters)
(16) 5/16" Split Lock Washers (For Casters)
(16) 5/16" Flat Washers (For Casters)
(16) 5/16” Hex Nuts
(18) 1/4-20x3/4” Socket Head Cap Screws (For Attachment of LocBoards.)
(56) Assorted LocHooks
(4) Hanging Bins
Note: While attaching LocBoards, it’s important to remember not to fully tighten any socket head cap screws
until system is fully assembled. Freedom of movement allows for proper alignment of cap screws and
preinstalled threaded fasteners.
Assembly: (Refer to Assembly Drawings attached)
1. Position the large bottom tray with the angled sides facing up.
2. Installation of LocBoard to bottom tray: Mounting holes for LocBoard are accessed through the square
holes on their front. Starting from the outside edge of the bottom tray with the square holes in the
LocBoard facing you, align the two bottom round mounting holes in the LocBoard flange with the 2 pre-
installed nuts in bottom tray. Using an Allen wrench, insert (2) socket head cap screws. (Make sure Cap
Screws go in straight and turn without restriction. You may have to move board slightly to allow
screws to turn freely.) Tighten cap screws until head is just below surface of the board. Repeat for
remaining LocBoards.
3. Installation of LocBoard to Top Tray. Please Note: One end of the Top Tray has 2 sets of holes on each
side without preinstalled fasteners. This is the end where the handle will be installed to the inside of
the top tray along with Swivel Caster. Starting from the opposite end of the top tray, align mounting
holes in the top of the LocBoard with preinstalled nuts in the top tray. Using the Allen wrench, insert (2)
socket head cap screws. (Make sure Cap Screws go in straight and turn without restriction. Tighten
until cap screw heads are just below surface of the LocBoard. Repeat for LocBoard on the opposite side
from the one just installed.
4. Installation of Handle. NOTE: There will be one extra pre-installed nut in the handle and one extra hole
in the top tray that does not align with a mounting hole in the LocBoard flange and will require a
socket head cap screw be inserted through just the square hole in the LocBoard. Align the outside
LBC-18H - 36-3/4 In. L x 39-1/4 In. H x 21-1/4 In. W Anodized Aluminum Frame Tool Cart
with Tray, 56 pc LocHook Asst & 4 Hanging Bins