Use and Care Guide

10
GB
Problem Possible cause Solution
Red LED does not illuminate and Battery
(9) not charging
Battery not fully seated Refit battery correctly
Battery Charger (13) not powered Recheck mains connection
Battery has low capacity
Battery not being fully charged Wait until Green LED is illuminated
Battery has been charged over 100 times and
capacity has started to reduce
This is normal for batteries. Contact your Triton
dealer to purchase a replacement battery
Saw cannot be switched on (Trigger (6) does
not move)
Trigger Lock (5) is engaged Move Trigger Lock to the unlocked position
Saw does not start when Trigger is pressed
Battery completely discharged
Recharge Battery or replace with a fully charged
battery
Defective Battery Replace Battery
Saw defective
Contact your Triton dealer or authorised service
centre
Poor cutting action
Worn or incorrect blade Replace blade
Material may be beyond the capabilities of the
saw with the fitted blade despite the blade
matching the material
Replace blade with a finer tooth pitch blade to
reduce the load on the saw motor
When cutting an unsecured workpiece, the
workpiece is vibrating and moving with the cut
There is a gap between the Shoe (1) and the
workpiece
Ensure there is no gap, see Fig. D
The blade is bi-directional
Use a uni-directional blade so it mainly cuts as it
pushes the material towards the Shoe (1)
The blade tooth pitch is too coarse
Use a finer tooth pitch so less material is cut per
reciprocating action and smoother cutting
Troubleshooting
103935_Z1MANPRO1.indd 10 26/09/2014 11:17