Installation Manual Owner's manual

FT5000

- SITE PREPARATION AND INSTALLATION GUIDE

Figure 5. Mount cabinet on plinth.

Sleeve

5. If no plinth is needed, slide the unit forward towards the wall opening so the

sleeve protrudes slightly out the front exterior (Figure 4). This is needed to

temporarily affix the control panel trim. Minor adjustments for raising the

unit can be made using the cabinet leveling feet (See “Adjusting Height of

Unit” page 30).

6. If a plinth is used (either built or purchased), mount the cabinet on the plinth

Figure 5). The optional plinths have a wall tab that is aligned facing the outside

exterior wall. Anchor the cabinet to the plinth using the bolts provided (optional

plinth) or secure to your built plinth. Tighten bolts enough to secure the two

together for moving the unit.

7. Slide/move the unit forward towards the wall opening so the sleeve protrudes

slightly out the front exterior (Figure 4). This is needed to temporarily affix

the control panel trim. Minor adjustments for raising the unit can be made

using the plinths leveling feet (See “Adjusting Height of Unit” page 30).

Figure 4. Sleeve pr otrudes slightly.

8. Locate the control panel trim included with the unit accessories. On the back

side are 4 clips (Figure 6a) that will align with 4 slots on the control panel (Figure

6b).

**Caution**

When placing the unit on the plinth, be careful not to damage the

front of the sleeve as this has the control panel electronics and

hardware mounted.

Note

Before installing the plinth, adjust the leveling feet a 1/4" (6mm) below the

platform to gain access with an open-end box wrench for additional

adjustments.